How would I attach reed or GN fencing to a chain link fence?

It is easier to attach the reed onto the fabric side of the existing fence. If you must install on the side with the rails and posts, install a 2x2 or similar pressure-treated "dummy rail" about 4" up from the ground from post to post. The dummy rail can be wired to the posts with galvanized bailing run through holes in the 2x2. This will give you two vertical planes (dummy rail and top rail) on which to attach the fence.



In any case roll out the fence and lean it against the the chain link. Place a board (something about 3/4" thick) on the ground and let the fence rest on it while wiring the rolled fence to the chain link. Use galvanized bailing wire, 16 gauge is fine. It is easier if there is someone on both sides of the fence. Make "U" shaped lengths of wire long enough to go through both fences and have enough room left to twist on the side opposite to the rolled fence. Install wire across the wire lines of the rolled fence at the rail and the dummy rail or, if you are applying to the chain link fabric side, anywhere convenient. Do this every 3 to 6 inches at top and bottom. Maybe a few in the middle as well. Then remove the board and set it down for the next run. The object of the board is to leave a drip space at the bottom to keep the fence out of the dirt.



When all done it is wise to add a batten at the top rail and the bottom (dummy rail if used). There are instructions on the web site about battening. Essentially it is another set of rails that squeezes the rolled fence against the chain line and keeps it from flapping in the wind and failing in fatigue.